Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot key fob suddenly stopped functioning, it could be because of a dead coin-cell battery or water damage, receiver module issues, or even a defective chip. These are all easy solutions that will get your car back up to speed in a matter of minutes!
The key blade could become worn out and lead to an unusable car key. It is easy to fix the issue by visiting your local Car Key Man Auto Locksmith to replace the blade.
Battery
The key fob battery in your Peugeot 308 can sometimes die or become insufficient to send a strong signal to the car. This can cause the key fob to stop functioning, preventing you from locking or opening the doors or even starting your engine. You'll require a new battery for the key fob in order to fix this.
You can buy a brand new battery at an auto parts store, or at your local hardware store. When you purchase the battery make sure that it's brand new and hasn't been sitting on the shelf for too long. A new battery has greater capacity and can send a stronger signal to your vehicle.
After replacing the battery If you have a new battery, try unlocking and locking the doors of your Peugeot with the key fob. If the doors do not unlock, the problem is likely with the car's receiver module which can be changed by your local Peugeot dealer.
It's also possible that the chip inside your key fob is damaged. You could damage your key fob if you drop it on the ground, or expose it to moisture. The rubber seals that protect your chip from moisture can get worn out over time. This is especially the case if you expose your key fob to water for extended periods of time, such as swimming it in the ocean. To prevent this from happening, you should keep your key fob free of moist areas and away from water.
Water Damage
If your key fob gets soaked, regardless of whether you dropped it in the pool or threw it into a puddle don't think that it's an accident. The key fob is protected by rubber seals, however, prolonged exposure to water can affect the electronic chip. Water is a good conductor and any water that is absorbed into the key fob could cause a series short circuits that eventually destroy the electronic chip. After removing the batteries clean the contacts with isopropyl and then dry them completely before putting them back in.
Your Peugeot 308 may not start due to a dead battery. If you have an extra car, jumper cables can be used to get the engine going again. If the battery is causing the problem, it will need to be replaced.
A bad receiver in the car could also block it from receiving the signal from the keyfob. The key fob could be damaged or there may be a problem with the antenna, wiring or key fob itself. It is possible to program a new keyfob for your vehicle if you are using one. If you are unable to fix the problem, contact an expert technician. A technician who is trained in the field will be able determine the issue quickly and then fix it right away.
Radio Interference
Symptoms such as key fob not being recognized or having a restricted range often mean that there is an interference in the system. The interference could be radiated or transmitted, the latter resulting from speaker and power cables passing too close to electrical components. Generally, re-routing the cables or moving them away from the components may resolve the issue.
peugeot 206 key replacement G28 Car Keys is listening to your key fob's signal in attempt to steal your vehicle or vehicle, but it's possible that radio frequency interference has drowned out the signal. Fortunately, this is not a problem to repair.
If you're experiencing a problem with your keys that are not recognized, try an entirely new battery. Also, ensure that the battery is the right size and type. Batteries that aren't the correct size can damage your fob.
These devices could interfere with the key signal, if they utilize the same radio frequency. It is best to avoid having these devices attached to your key fob.
Pairing Issues
The remote keyless entry system has a receiver that receives radio frequency signals from the key fob. If the receiver has developed a problem, you won't be capable of starting your car regardless of whether the key fob works and can be reset. This issue can be caused by a variety of ways, such as a dead battery in the coin-cell, or water damage. The receiver may also be malfunctioning due to a software glitch or internal damage in the key.
The battery inside your Peugeot 308 keyfob has probably been drained. The battery can be replaced, but you must be sure it's the appropriate battery for the keyfob. It is best to choose one that is the same size, voltage, and specification as the original.
Another reason that your Peugeot 308 key fob might not be working is due to the fact that it is paired with a different car. This could be the case if you have given your key fob to someone else or if the key has been used to unlock or start other vehicles. This can be resolved by reprogramming the key fob with an OBDII scanner. This tool will usually ask you for specific details regarding your vehicle, such as the VIN or engine type, so it's important to enter this information correctly.